![]() ![]() Of Bachelor of engineering in Electrical and Electronics EngineeringĭEPARTMENT OF ELECTRICAL AND ELECTRONICS ENGINEERING Project Report submitted to NMAM Institute of Technology, NitteĪn Autonomous Institution affiliated to VTU Belgaum, in partial fulfilment for the award of Electrical and Electronics Engineering Implemented Compensator and PWM scheme using NXP LPC1768 Micro-controller.Īssistant Professor, Dept. Gain margin using MATLAB Designed PID compensator by modifying the open loop buck converter circuit obtained by Simulation using ORCAD (PSpice). Circuit Simulation using ORCAD (PSpice) Stability analysis of the closed loop system for desired phase and.Designed and developed a buck converter circuit using the PID Compensator to get a stable output of 5V-5A from an input of 12V.The error signal is compared with a saw-tooth ramp voltage and desired PWM signal. This project involved simulation, design and hardware construction of voltage mode control of buck converter using PID compensator. ![]() To get the regulated output voltage, compensation mechanism using voltage mode control is used. The buck converter is designed in continuous current conduction mode. Voltage Mode Control of Buck Converter (Dec 2012 - April 2013): The Buck-converter converts an input voltage into a lower output voltage, it is also called step-down converter. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |